3 Comments

Sound: *********1/2
Value: *******1/2
(Read about our ratings)

Measurements can be found by clicking this link.

Reviewers' ChoiceAs I’ve written before, headphone amps are typically more critical to headphone sound quality than speaker amps are to speaker sound quality. That’s largely because there’s so little standardization of headphone impedance and amplifier output impedance. The amp might be even more critical to the sound if you’re using expensive headphones of the type Focal is known for, such as the Utopia ($3999 USD) and Stellia ($3000) designs. So it’s no surprise that Focal launched the Arche ($2500), a high-end DAC-headphone amp with features intended to get the best sound out of the company’s headphones.

Although the Arche can drive any headphones, its front-panel menu offers specific EQ curves for five Focal headphone models: the Clear, Elear, Elegia, Stellia, and Utopia. This is an ideal way to build a headphone amp, because even the most expensive passive headphones have response flaws. Why? Because they’re tuned solely through physical adjustments to the driver and enclosure -- a method far less precise than, say, putting a resistor-capacitor-inductor network in a speaker to tame a response peak, or making an adjustment in a digital signal processor.

Focal

The Arche’s most obvious calling card is its integral headphone stand, but the amp itself is also interesting. It’s a class-A, dual-mono circuit designed in conjunction with Micromega, and it offers Voltage and Hybrid modes. The former is what’s found in most modern solid-state headphone amps, while the latter is intended to make the Arche more of a current-drive amp. Although no other details are provided, I suspected (and confirmed through my measurements) that the current-drive mode adds additional output impedance -- an idea that’s long been used in speaker amps, most notably in many Sunfire models. If you’re using dynamic-driver headphones with a non-flat impedance, the added impedance in the amp’s Hybrid mode will react with the headphones to change their sound slightly.

The internal DAC accepts digital audio in PCM resolutions up to 24-bit/384kHz, and DSD in resolutions up to 256 (4x). It has USB, coaxial (RCA), and optical (TosLink) inputs.

Unbalanced RCA analog inputs are also provided, along with unbalanced RCA and balanced XLR outputs that let you use the Arche as a DAC with a conventional stereo system. There are two headphone outputs: balanced output on a four-pin XLR jack, and unbalanced on a 1/4" (6.3mm) jack.

Focal

Focal Naim America, the North American distributor, also offers the Arche in package deals with various Focal headphones: $3000 for the Arche and the Clear, $4000 for the Arche and the Stellia, and $5000 for the Arche and the Utopia. That cuts the cost of the amp down to $1500 with the Clear and $1000 with the Stellia and Utopia headphones.

Let’s get started . . .

In the box

The Arche includes the amp, the stand, four dime-sized silicone pucks for its mildly spiked feet to sit on (so as not to scratch the surface underneath, I assume), and a power cord.

Use

Setting up the amp requires only connecting the source(s) and attaching the headphone stand (which you can leave off if you prefer).

Focal

A single knob/push-button adjusts volume and controls the menu system. I didn’t need to use the manual to figure out the menus, which let you select Low or High gain, flip the phase, choose between Voltage and Hybrid modes, and select one of the five Focal headphone-specific EQ settings.

Sound

There’s so much to listen to here: evaluations of the amp and the DAC, and of the various EQ modes.

I started by comparing the Arche to my Audio-gd NFB-1AMP, a very well-made, high-powered amp I’ve found capable of driving any headphones. In this case, I used an iFi Audio xDSD DAC-headphone amp as a DAC to feed the Arche and the NFB-1AMP, using my Neutrik Minilyzer ML1 audio analyzer to match the levels to within ±0.09dB. No matter what music I played, the comparison was close. Although with more delicate, detailed material, such as “You Are So Beautiful,” from Casey Abrams’s Jazz (16-bit/44.1kHz AIFF, Chesky), the Arche seemed to have just a bit more air and detail in the treble.

Focal

I then tried using the Arche with the most difficult-to-drive headphones I have: the HiFiMan HE6se’s. In its High gain mode, the Arche drove the HE6se headphones fairly well. Although I initially put on a Patricia Barber side for this test, I quickly came to my senses and put on something more crankable: the live version of “Cold Gin,” from Kiss’s Alive (16/44.1 FLAC, Casablanca/Qobuz). Even through the HE6se’s, there was volume to spare, and hearing all the detail in the unison guitar parts at the end of the instrumental section was downright thrilling. Pretty good for a band that’s not exactly revered for its virtuosity.

The DAC built into the Arche seems quite good as well. I evaluated it by using the xDSD with the Arche’s analog input, and a direct connection with the Arche’s USB input, matched to within ±0.06dB. I thought the Arche’s internal DAC was just a hair better -- for example, giving me a tad more definition and detail in Casey Abrams’s voice on “You Are So Beautiful,” and having no discernible tonal balance or tilt of its own.

To test the EQ modes, I first plugged in the Utopias and switched back and forth between the Voltage and Utopia modes. Listening to Casey Abrams’s Jazz, I couldn’t tell the difference, other than a very slightly reduced volume when I used the Utopia mode. I wondered if bassier material would make the difference more clear, so I switched to Trapeze’s “Black Cloud” (Medusa, 16/44.1 FLAC, Threshold/Qobuz), a classic early-1970s power trio recording. Here, I could hear that the Utopia mode introduced a very subtle downward tilt in the tonal balance, with just a tad more bass and a tad less treble. I liked this better. “Black Cloud” sounded great through the Utopias with the amp in Voltage mode, but engaging the Utopia EQ more gave it even more kick.

Focal

Focal also sent me a set of Stellia headphones to try with the Arche. In this case, the difference was more noticeable -- again, a tilt toward the bass and away from the treble, but more of a tilt, and a bigger reduction in volume -- and I can’t say it really improved the sound of the Stellias. It made them sound more mellow, but to me, you buy headphones like the Stellias because you want to hear that treble and you want to hear that detail.

I also tried the Hybrid mode versus the Voltage mode, but with the Utopia and the Beyerdynamic Amiron Home (impedance rated at 250 ohms but measured more like 300) headphones, I had a hard time hearing any difference, even on demanding material such as the new album Periphery by singer Priya Darshini (24/96 AIFF, Chesky).

Comparison

As I don’t panel-test headphone amps, I’m comparing the Arche with similar ones in its approximate price range.

I haven’t tested a colossal number of high-end headphone amps, but one I have tested and liked -- although I dinged it for being pricey -- is the Lehmannaudio Linear USB II ($2199). It’s a wonderfully simple, very good-sounding product, but the Arche offers much more for its only-$300-higher price: more digital inputs, balanced output, DSD, and, of course, the integral stand. My power output and frequency response measurements for the two are similar.

Focal

A closer competitor might be Sennheiser’s HDV 820 ($2399.95). I haven’t tried it, but it seems quite similar to the Arche, with most of the same features -- plus a 4.4mm balanced output, and minus the Arche’s integral stand.

Conclusion

I think listeners who have invested four bills in high-end Focal headphones should probably buy the matching Arche amp. It’s very well-engineered, and includes a thoughtful feature set and a friendly design. I do admit that I’d hoped Focal would do more intensive EQ within the Arche to optimize the sound of its headphones -- the tweaks it made are well within the capabilities of even rudimentary equalizers -- but the company’s headphones are among the most revered in the industry, so I guess if it ain’t broke, don’t fix it.

The Arche is a good buy if you already have Focal headphones, but if you’re buying Utopias or Stellias, you’d be crazy not to add an Arche.

. . . Brent Butterworth
This email address is being protected from spambots. You need JavaScript enabled to view it.

Associated Equipment

  • Headphones -- Focal Utopia and Stellia, HiFiMan HE6se, Beyerdynamic Amiron Home
  • DAC-headphone amplifier -- iFi Audio xDSD

Focal Arche DAC-Headphone Amplifier
Price: $2499 USD.
Warranty: Three years parts and labor.

Focal
BP 374, 108 rue de l’avenir
42353 La Talaudière Cedex
France
Phone: (+33) 4-77-43-57-00

North American distributor:
Focal Naim America
313 Rue Marion
Repentigny, QC J5Z 4W8
Canada
Phone: (800) 663-9352

Website: www.focal.com

Say something here...
You are a guest ( Sign Up ? )
or post as a guest
People in conversation:
Loading comment... The comment will be refreshed after 00:00.
  • This commment is unpublished.
    · 8 months ago
    Mehdi from Paris - Hi !! Nice review ! I have something to add : There is no EQ mode in the Arche. You wanted more differences between the modes but they are in fact just power modes. It is actually power modes, to drive headphones properly. For example tu Utopia mode is the perfect power for Utopia Headphones. If you have something else than a focal pair (Hifiman for example) it is recommand to use Voltage or Hybrid. Voltage has a bit more punch (energic listeling), Hybrid is smoother (relax listening). You still can try the other modes, only your ears will found the perfect match.
    Thanks for your tests, I also found this amp very impressive !
  • This commment is unpublished.
    · 4 years ago
    Great review Brent. I own a pair of Utopias and use my iPhone as the musical source. How would I connect the headphones to the front of the amp when I only have a 3.5mm input jack? And how do I connect my iPhone as the input source?
    • This commment is unpublished.
      · 4 years ago
      Hi, Scott. To connect the headphones to the amp, just use a 3.5mm to 6.3mm (1/8" to 1/4") adapter. I have to apologize, I should have mentioned something in the review about iOS/Android compatibility. (I usually just use a PC to review high-end DAC-amps.) I wasn't able to get my Samsung S10 Android phone to connect digitally, but Focal says an update for that is on the way. Focal says iOS devices will connect digitally; in fact, they use an iPad for their demos. You will need a Lightning-to-USB adapter for that.
      • This commment is unpublished.
        · 3 years ago
        Can you please tell me how to increase the usb sample bit rate when my iphone is connected to the arche? It is currently only set at 48kHz.
        • This commment is unpublished.
          · 3 years ago
          I'm sorry, I am the furthest thing from an iOS expert. I keep an iPad and iPod touch around, but only to use for occasional testing. Somebody on the audio forums ought to know how to do that if it's possible.
  • This commment is unpublished.
    · 4 years ago
    Another great review, Brent! Your writing is always so in-depth yet approachable. I’m a beginner when it comes to headphone amps, and I’m curious about your last line “if you’re buying Utopias or Stellias, you’d be crazy not to add an Arche”. One of my main takeaways from your review of the Stellias was that they didn’t need any sort of headphone amp, let alone one that costs 80% of their standard price (without the special bundle pricing). And while specific amplification modes designed for each Focal headphone is genuinely a great idea that could be worth the extra cost, you say in this review that you weren’t that fond of the Stellia preset. Can you expand more on the benefits of the Stellia + Arche combo?
    • This commment is unpublished.
      · 4 years ago
      Thanks, John, I really appreciate hearing that!

      You can see in the measurements that the EQ for the Stellias is just a simple tonal balance tilt. For me, it makes the Stelllias sound a little too soft. But you don't have to use it, of course, and it's a very good amp-DAC. Purchased with the Stellias, it's only $1000. I'm not the guy who thinks expensive headphones necessarily demand an expensive amp, but the Stellias will sound better with a high-quality amp-DAC, and most people buying $3000 headphones will use them with some sort of amp.

Latest Comments

What a great post! I really appreciate how you’ve made a complicated topic so much ...
@Geoffrey MorrisonThanks, Geoffrey.
@Brent ButterworthHi Brent, thanks for your offer of help, and Merry Christmas, and apologies for the ...
Yes, features matter because they define the value and functionality of a product, service, or ...
@Alan LofftHi, Alan. We didn't press CDs, Audiophile Society just does downloads. Shoot me an e-mail ...
Geoffrey Morrison 22 days ago Beyerdynamic DT 770 Studio Headphones
@Josh slootIn case anyone is wondering, this is a bad idea.
@Alan LofftIf you still need assistance, try the Audiophile Society's contact page:
https://theaudiophilesociety.com/pages/contact
Jorden Guth 22 days ago Ollo Audio S5X 1.1 Headphones
@Doug SchneiderI do indeed have a pair of the Ollo S5X's. I primarily use them for ...
Hey, incredible reviews as always
I wanted to ask which one of these is better and ...